Jumper Settings - Exsys Ex-1183Hmvs Anleitung

4 port usb 3.1 (gen1) metall hub mit 1,5a strom pro port und 15kv esd überspannungsschutz

Inhaltsverzeichnis

Verfügbare Sprachen

English

EX-1183HMVS

3. Layout, Connections & Jumper Settings

3.3 Jumper Settings

The EX-1183HMVS will be delivered with the setting Bus-Power.

But you have the

possibility to cut the power at the data line.

For this you open the case with the four

screws on both sides. Then you must set the jumper JP3 from ENA (Enable) to DIS

(Disable). See the following picture.

Attention! Please do not change Jumper JP2, because this will only be used by pro-

duction for test purposes!

JP3

DIS

ENA

Inhaltsverzeichnis