Head / Neck Support; Moving Upwards / Downwards - Lopital Reflex Benutzeranleitung

3.4. Head / neck support

• The Reflex has a head / neck support that can be adjusted
in terms of both height and depth .
• In order to set its height, the rotating button (1) on the back
of the chair must be undone . Once you have reached the
required height, do the button up again (See figure 17) .
• To set the depth of the head / neck support, the handle (2)
is unlocked . Once you have reached the required height, do
the handle up again . The depth setting has a range of 7 cm .
• The Reflex has a curved head / neck support, allowing the
head of the client to be supported effectively .
Always replace this component on the chair when you have finished using it.
This will avoid the component being lost.

3.5. Moving upwards / downwards

Moving upwards
• If the client is seated in the chair, first apply the brakes to the wheels
and then move the chair upwards .
• Move the chair upwards by pressing the button that shows an 'up'
arrow . The seat will then move upwards simultaneously
(See figure 18) .
• You can stop the movement whenever you like by taking your finger
off the button .
• During the upward movement, maintain contact with the client .
Moving downwards
• Move the chair downwards by pressing the button that shows a 'down'
arrow . The seat of the Reflex will move downwards simultaneously
(See figure 19) .
• You can stop the movement whenever you like by taking your finger
off the button .
• During the downward movement, maintain contact with the client .
Before moving the chair downwards, check to ensure there are no persons or
objects in the vicinity of the chair.
38 | Instructions for use | Reflex Shower-toilet chair
2
1
Figure 17 Head support .
Figure 18 Moving
upwards .
Figure 19 Moving
downwards .