Program Settings; Start Guide; Menu System - Nibe ECS 40 Installateurhandbuch

Program settings

Program setting of ECS 40 can be performed via the start
guide or directly in the menu system.

Start guide

The start guide appears upon first start-up after heat
pump installation, but is also found in menu 5.7.

Menu system

If you do not make all settings via the start guide or need
to change any of the settings, this can be done in the
menu system.
Menu 5.2 - system settings
Activating/deactivating of accessories.
Menu 5.1.2 - max flow line temperature
Setting the maximum flow temperature for each climate
system.
Menu 5.3.3 - extra climate system
Mixing valve settings for extra installed climate system.
Menu 1.1 - temperature
Setting the indoor temperature.
Menu 1.9.1 - heating curve
Setting the heat curve.
Menu 1.9.2 - external adjustment
Setting external adjustment.
Menu 1.9.3 - min. flow line temp.
Setting the minimum flow temperature for each climate
system.
Menu 1.9.4 - room sensor settings
Activating and setting the room temperature sensor.
Caution
Also see the Installer manual for F1145/F1245.
GB
21