AURES YUNO-151 Bedienungsanleitung Seite 31

4.2 Install the Attachment-type Customer Display (YUNO-VFD)
Second Display (YUNO-2NDLCD10.1)
The Attachment-type Customer Display (YUNO-VFD)
(YUNO-2NDLCD10.1)
unit is powered off before starting.
Please follow the below steps to finish the installation :
1. Unscrew the two pcs of screws from the rear top service door and remove it.
2. Connect the Customer Display cable with the connector of the system. Locate this
connection properly.
3. Insert the Customer Display in place and fasten the two pcs of screws to make it
secure.
Installed with YUNO-VFD
*Apply the above procedures when installing the Attachment-type Customer
Display (YUNO-VFD) and Second Display (YUNO-2NDLCD10.1) on Touch Monitor
series.
**Please get Prolific USB-to-COM driver from AURES Technical Support Website
when connecting Touch Monitor with YUNO-VFD (which is RS-232 interface).
can be installed from the rear top side of the system. Make sure the
Installed with
YUNO-2NDLCD10.1
26
and Second Display
and