AURES YUNO-151 Bedienungsanleitung Seite 26

3.5 Install the Wall-mount
Before you begin, make sure you have two screws that indicate a diameter
measurement of 0.1377nches (3.5mm).
1. Determine where you want to mount the YUNO.
2. Drill two holes into the wall. Make sure adjacent holes are 2.95 inches (75mm) apart.
3. Insert a screw into each hole, and leave 0.2inches (5mm) of its head exposed.
4. Maneuver the YUNO so the wall-mount slots line up with the two screws.
5. Place the wall-mount slots over the screws and slide the YUNO down until the
screws fit snugly into the wall-mount slots.
YUNO follows VESA Mounting Interface Standard to allow you to mount the elegant
bezel-free panel PC to a stand or wall with four M4 screws easily.
The horizontal and vertical distance between the tapped holes on YUNO is 75 mm.
Make sure the system is powered off before starting.
21