Getting Started; Zeroing (Calibration) - T4W TW-2B Bedienungsanleitung

TW-2B/TW-6/TW-6s

2. Getting started

Coating thickness gauge is designed to measure the thickness of a steel,
galvanized steel or aluminium sheet paint coating. The measurement resolution
equals 10µm. The device is equipped with an internal EEPROM memory for 100
measurements which enables to check the results after the measurement is
made. The memory doesn't get deleted after turning off the device, although it
is possible to delete it from the menu. The device has a LCD back-light which
makes measuring in places with insufficient light (e.g. garage) much easier.
Before You start to use the device, please place a new alkaline battery or a fully
charged accu in the back side of the device's housing. In order to do it please
take off the battery flap and place correctly the battery or accu by connecting it
to the clips on the cable.
WARNING!
taken on older cars with non-galvanized steel bodywork, the „Steel" option shall
be chosen.

Zeroing (calibration)

Before You start to take measurements, please check whether the gauge is
calibrated. To do it properly, please select the
menu and put the sensor against the green side of the calibration sheet. If the
display shows a 0 +/-10µm value, it means that the gauge is calibrated. Should
the aberration be larger than 0 +/-10µm, please put the sensor once more
against the green side of the calibration sheet, wait until the result stabilizes
and press the OK [MENU]
the display will appear a
to the main menu.
If the device is calibrated, You can cancel the
button. Please note not to press the
[MENU]
OPERATION MANUAL
The device is pre-set to galvanized steel and
aluminium (Zn/Al)! Should the measurement be
button while the sensor still touches the sheet. On
caption and the device will return automatically
OK...
function from the main
Zero
function by pressing the
Zero
button before the
OK [MENU]
www.t4w.eu
OK
6