TW-2B/TW-6/TW-6s
Off function
After You accept this function with the
Substance function
The substance function allows You to choose the material which will be
measured. You have the following possible choices:
• galvanized steel / aluminium (Zn/Al);
• steel (Fe);
• reference point (Ref)
You can switch between the sheet materials with the
accept the selection press the
Reference point function
To take the measurement in reference to a
sample You can use the reference point function.
You can easily compare the further results with
a sample one.
After choosing this function on the display will
appear a
Set Ref
the second
-------
sensor against the sample sheet, wait until the
result stabilizes and press the red button to set
the reference point.
Then, to take the measurement according to the reference point, You have to
choose the „reference point" option in the substance function menu. During the
OPERATION MANUAL
OK [MENU]
caption in the first line and in
. In that moment please put the
button the device turns off.
OK[MENU]
button.
www.t4w.eu
FUNKTION
button, to
Set.Ref
*
--------
10