Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
We recommend you to use the optional speaker stands (SPS-HF101/SPS-LF101) for setting the speaker. Please
refer to the owner's manual included with the speaker stands for specific installation instructions.
This speaker may also be hung on a wall, utilizing the key holes on the rear of the speakers.
Wall mounting for the front/surround speaker
* Do not use this screw
hole.
The screw holes are designed
specifically for use with the inch
screws supplied with the SPS-
HF101 and SPS-LF101 speaker
stands (sold separately).
Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the rear of the
speaker on the protruding screws.
Make sure that the screws are securely caught by the narrow sections of the "key hole" opening.
WARNING:
• The speaker weights 3.6 kg (7.92 lbs). Do not mount them on thin plywood or a wall with soft surface
material. If mounted, the screws may come out of the flimsy surface and the speakers may fall. This
damages the speakers or causes personal injury.
• Do not fasten the speaker to a wall with nails, adhesives, or any other unstable hardware. Long-term use
and vibrations may cause them to fall.
• To avoid accidents resulting from tripping over loose speaker cables, fix them to the wall.
• Secure installation is the purchaser's responsibility.
SETTING UP THE SPEAKER
Use the key hole
Use the key hole
Wall / wall support
Tapping screw
(Available at the
hardware store)
Screw
diameter
4~4.5 mm
*a
*b
(1/8"~3/16")
*a: Min 38 mm (1-1/2")
*b: 5.5 mm (7/32")
3
E-
Werbung
Inhaltsverzeichnis
