ASROCK K7S41 Handbuch Seite 11

2.4 Jumpers Setup 2.4 Jumpers Setup 2.4 Jumpers Setup 2.4 Jumpers Setup 2.4 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "SHORT". If no jumper cap
is placed on the pins, the jumper is "OPEN".
The illustration shows a 3-pin jumper whose
pin1 and pin2 are "SHORT" when jumper cap
is placed on these 2 pins.
Jumper Setting
K7S41:
FSB Select
Jumpers
(see p.2/p.3 No. 27)
K7S41GX:
Note: The setting of the CPU front side bus frequency of this motherboard is by means of the
adjustment of jumper-setting. You must set the FSB jumper according to your AMD CPU
before you use the "Manual" option as the FSB setting in BIOS setup to perform over
clocking. Please follow the figures above to set the CPU front side bus frequency.
PS2_USB_PWR1
(see p.2/p.3 No. 1)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by power
supply.
JR1
(see p.2/p.3 No. 24)
JL1
(see p.2/p.3 No. 23)
Note: If the jumpers JL1 and JR1 are short (see the figure above), both front panel and rear
panel audio connectors can work.
ASRock K7S41 / K7S41GX Motherboard
Short Open
Short pin2, pin3 to enable
+5VSB (standby) for PS/2 or
USB wake up events.
1 1 1 1 1 1
1 1 1 1