Epson TM-P80 Benutzerhandbuch Seite 12

English
1. Make sure that the printer is turned off.
2. Turn the lever to the
illustration C.
3. Install the battery (D 13).
4. Close the battery cover, and turn the lever to the
5. Connect the AC adapter to the printer. See illustration F 14 for the connecor.
Recharging starts.
Notes:
Recharging will take approximately 2.5 hours with the AC adapter or with the optional
battery charger OT-CH60II. For detailed information on the battery charger, see its user's
manual. The time described above is the time required to charge a battery pack that is fully
discharged.
Recharging the battery at 35
the printer, which may require a longer charging time than the specified one. The Charge
LED flashes while the charge is stopped.
Installing or Replacing Roll Paper
Follow the steps below to install or replace the roll paper.
CAUTION:
Be sure to use roll paper that meets the specifications.
Note:
Do not use the roll paper that have the paper glued to the core.
1. Press the open button to open the roll paper cover. See illustration G.
2. Remove the used roll paper core if there is one, and insert the new roll paper.
See illustration H.
Note:
Note the direction the paper comes off the roll.
3. Pull out some paper, close the cover, and tear off the paper with the manual
cutter. See illustration I.
Installing or Replacing Roll Paper Vertically
You can hang the printer vertically on a belt using a belt clip on the back of the
printer. When you use the printer vertically, follow the steps below to install the
roll paper.
Note:
Be sure that the roll paper holder is on the bottom when you use the printer vertically.
1. Press the open button to open the roll paper cover.
2. Remove the used roll paper core if there is one.
3. Set the new roll paper. See illustration J.
Note:
Note the direction the paper comes off the roll.
Pull the leading edge of the roll paper. See ➀ in illustration K.
4.
Align the left edge of the roll paper with the edge of the cover. See ➁ in
5.
illustration K.
6. Close the roll paper cover and tear off the paper with the manual cutter.
6 TM-P80 User's Manual
mark, and slide the battery cover to open it. See
C {95°F} or higher activates the internal temperature control of
°
mark. See illustration E.