Telcoma AF124 Installationsanweisungen Seite 39

GB
PROGRAMMING WORK and PAUSE TIMES
During programming the control unit has a self-learning capability with regard to work and pause times.
The S/S command will be activated several times during programming (item 10 of Fig. 1), alternatively the
Pp command can be used (terminal 16 if Fig. 2 or the remote control (if stored).
Important notes before programming:
A. Power the control unit and check correct operation of the control inputs through the relative LEDs (the
N.C. contact LEDs should be on).
B. Free the area of gate movement.
Pre-calibration or check procedure can be made on the magnetic limit switches during programming.
Procedure:
- Release the motor. The gate must move freely
- Enter "pause and work time programming" and proceed through to point 5
- Manually move the gate in the vicinity of the limit stops
When the control unit detects the magnet, led LD1 and the indicator lamp flash.
- make calibrations as required
- block the motor and proceed with point 6, or reset to exit programming mode.
For precise stopping at the limit stop positions, enable the deceleration interval.
Programming:
STOP
A
A
STOP
B B
STOP
1- Manually move the gate to mid-stroke.
2- Press and hold PROG to reset, and use a screwdriver to short the jump Reset (detail 9 of fig. 1).
3- Keep the Prog key pressed.
4- After three seconds led LD1 (and indicator lamp) turns on.
5) - Programming procedure activated
6) - Press the S/S button to start the self-learning process.
7A, 7B) - The motor performs a brief manoeuvre to check correct direction of rotation.
8A.9A) - If gate closing is activated presses S/S again to complete the manoeuvre.
STOP STOP
LD1
STOP
STOP
LD1 LD1
A
B
13 14
LD1
STOP
39