Hilti TE 76 Bedienungsanleitung Seite 17

Main features of the tool
Electrical protection class II (double insulated) Z
Active Torque Control TE76-ATC / TE76P-ATC
(additional operator protection in drilling mode)
Mechanical torque-limiting clutch
No-load hammering absorption
Grip and side handle with vibration absorption
Quick-change chuck
TE-Y insert tool system
Infinitely variable speed, with electronic regulation
independent of load
Selector switch for full power (II) and half power (I)
Drilling and chiselling modes
Control switch lockable in chiselling mode
24-way chisel position adjustment
Gearing and hammering mechanism with oil lubrica-
tion
Automatic cut-out carbon brushes
Service indicator with light signal
Pivotable side handle
Depth gauge attachment (optional)
Right of technical changes reserved
The tool is designed for the following uses:
Use
Drilling in concrete, masonry
and natural stones
Chiselling in concrete, masonry Pointed, flat and shaped chisels
and natural stone
Setting anchor
Drilling in wood and metal
Mixing non-flammable
materials, e.g. grout
12
Printed: 07.07.2013 | Doc-Nr: PUB / 5071194 / 000 / 00
Theft protection system (option TE 76P / TE 76P-ATC)
The tool may be equipped with the optional theft pro-
tection system. If the tool is equipped with this feature,
it can be activated and made ready for operation only by
way of the corresponding activation key.
Required insert tools
Drill bit with TE-Y connection end Drilling range in concrete
– Hammer drill bits
– Breach bits
– Percussion core bits
with TE-Y connection ends
Setting tools with TE-Y
connection ends
Chuck holder, item 263359
Keyless chuck, item 60208
Wood drill bits and metal drill bits Wood drill bits, 10–32 mm dia.
with smooth or hex. shank
Chuck holder, item 263359
Keyless chuck, item 60208
Mixing tools with smooth or
hex. shank
Working range
12– 40 mm dia.
40– 80 mm dia.
45–150 mm dia.
Surface finishing and breaches
All Hilti anchors with TE-Y setting tools
Metal drill bits, 10–20 mm dia.
Mixing tools, 80–150 mm dia.