Resolving Faults - Varimixer EASYLIFT 140 Bedienungsanleitung Und Ersatzteile

9.

Resolving faults

Fault type
The timing belt jumps on
the belt wheel (the belt is
making crackling noises)
The belt is skewed (the belt
squeaks)
The sledge jerks
The lifter does not respond
The lift works very slowly
Check the following
Is the belt slack?
Is the belt worn?
Is the belt running skewed in
the track on the top cog wheel?
Is the belt worn?
Is there dirt in the mast on
which the sledge runs?
Is there dirt on the sledge
wheels?
Check whether the item being
lifted is heavier than the lift's
capacity
Check the main fuse
Check that the batteries are
charged
Check the voltage of the
batteries
Check the charging frequency.
Does the light quickly change to
green when connected?
Solve
Tighten the belt using the screws at the
top of the mast.
Replace the belt
Adjust the screw at the top of the mast,
on the side to which the belt is skewed.
Replace the belt
Remove the dirt and wipe with alcohol.
Remove the dirt or replace the wheels.
Remove the item
Replace the main fuse
Connect the charger
Connect the charger
If the charger quickly changes to green,
indicates that the batteries should be
replaced or the fuse on the charger is
broken
Page 7