4.
Operating the lifter
4.1.
Easylift 60 II
The lifter is operated using the Commander located on the lifter's control panel.
This is used to operate the lifting and lowering function.
⇑
⇓
4.2.
Easylift 140
The lifter is operated using the rocker switch located on the lifter's control panel.
This is used to operate the lifting and lowering function.
5.
Batteries and charger
The batteries are charged with the charger. Connect to the 110-230V and the inlet charging on the lifter.
The batteries should be charged daily as total discharge can damage the battery or shorten its life.
The charger automatically charges the batteries and switches off when the batteries are fully charged.
The batteries are fully charged after approx. 8 hours.
5.1.
Easylift 60 II
Charger indicator
# 1 LED: Red = charge
# 2 Green = float charging and ready for use
5.2.
Easylift 140
Battery indicator
The lifter is equipped with a battery status indicator that indicates the battery status when the UP button is
activated.
Green indicator: The batteries are functionally charged.
Red indicator: Batteries must be recharged immediately.
Charger indicator
# 1 LED: Red = charge, Green = float charging
Safety when charging
Use only original charger. Check that the wires are in good condition, connect properly and correct
before applying power. Make sure there are no dirt or water in the plug or the inlet.
The lifter will lift as long as the Commander is turned
clockwise.
The lifter will lower as long as the Commander is turned
anticlockwise.
The lifter will lift while the button is pressed in the upper
end
The lifter will lower while the button is pressed in the lower
end
Page 5