Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Press and hold FN and M/ to initiate the syn-
chronization.
The status LED lights green during the synchronizati-
on process. When successful, it turns off.
•
In case your USB receiver is attached to a USB hub, connect it directly to a USB port
•
During the synchronisation process, the keyboard should be located close by to the USB receiver in
the surrounding environment has no influence on the radio transmission (for instance reduction/interferences due to metal
cases, other sources of interferences etc.).
Ensure that you use fully loaded batteries. In case of doubt, change the old batteries to new ones as a precaution before
retrying the synchronization.
4. Installation KSK-3205 BTM & KSK-3205 BTM Air
4.1 System Requirements
Precondition for the use of the keyboard is that your device (PC, notebook, tablet, handheld, etc.)
•
is hardware-sided Bluetooth-enabled (e.g. by an integrated Bluetooth module or external adapter)
•
software-sided (Bluetooth) supports faultlessly the HID profile
•
software-sided (operating system) supports faultlessly standard keyboard drivers with corresponding country code
4.2 Installation of the Keyboard using Windows
Ensure for the further procedure that the used Bluetooth driver software was installed
correctly on your PC.
In order to open up the battery case which is on the back side of the keyboard, apply
light pressure and pull the entire cover on the back of the keyboard downwards.
Now put in two type AAA 1.5V batteries, considering the right polarity in the battery
case.
Switch the on/off switch to On.
After connecting the Bluetooth adapter with your PC, the blue Blue-
tooth logo appears at the bottom right corner of the screen.
13
The resynchonization is initiated with the aid of the function key:
Press and hold the Fn-key together with the M/ -key for 2 seconds. This initiates the
pairing process and a synchronization signal is sent to the USB receiver.
The synchronization process can take up to 10 seconds. The LED (top, left corner)
will be blinking in green during this process. When it turns off, the pairing is complete,
the synchronization process is now finished.
Test the keyboard's functionality as described in section 3.3.
Hint: Another advantage of this radio transmission technology is the great number
of possible, from each other independant, radio channels. This enables an
undisturbed and safe functionality of several wireless keyboards in one room or in
the transmission range of 10m.
If the keyboard does not work after a resynchronization, follow the steps below in
order to solve the issue:
•
Repeat the synchronisation process as described in section 3.4.
necessary to repeat this routine several times, before the correct radio channel
is found.
Version 2.0 (2012/04/26)
...touch the difference
of your notebook or computer.
order to make sure that
●
© 2012 by MaxPoint Handelsges. mbH
Sometimes it is
Werbung
Inhaltsverzeichnis
