Customer Service; Replacing The Lamp; Installation - AEG AHB93321LW Benutzerinformation

14 www.aeg.com
Problem

7.2 Customer Service

If your appliance is still not working
properly after making the above checks,
contact the nearest Authorised Service
Centre.
To obtain fast service, it is essential that
when you apply for it you specify the
model and serial number of your
appliance which can be found either on
the guarantee certificate or on the rating
plate located on the external right side
of the appliance.

7.3 Replacing the lamp

The appliance is equipped
with a longlife LED interior
light.
WARNING!
Do not remove the lamp
cover at the time of
replacement. Do not
operate the freezer if the
lamp cover is damaged or
missing.

8. INSTALLATION

WARNING!
Refer to Safety chapters.
8.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Possible cause
The lid has been opened of-
ten.
The FROSTMATIC function
is switched on.
Products to be frozen are
placed too closely to each
other.
1. Disconnect the mains plug from the
mains socket.
2. Replace the used lamp with a new
lamp of the same power and
specifically designed for household
appliances (the maximum power is
shown on the lamp cover).
3. Connect the mains plug to the mains
socket.
4. Open the lid. Make sure that the
lamp comes on.
Climate
class
SN
N
ST
T
Solution
Open the lid only if necessa-
ry.
Refer to "FROSTMATIC
function".
Make sure that there is cold
air circulation in the appli-
ance.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C