3M PX5 Bedienungsanleitung Seite 15

When an indicator is lit or flashing
The indicators on the projector's control
panel light or flash to notify of problems, as
described below.
Indicator status
STATUS
Lit red
STATUS
Lit red
STATUS
Flashing red
(lit for 1 seconds/
off for 1 seconds)
STATUS
Flashing red
(lit for 0.5 seconds/
off for 0.5 seconds)
STATUS
Flashing red
(lit for 0.5 seconds/
off for 0.5 seconds)
STATUS
Flashing red
(lit for 1 seconds/
off for 1 seconds)
Should an indicator be in a condition other than normal or flash at a rate other than the aforementioned, disconnect
the power cable and contact your store of purchase.
Note
Should the projector not project properly, see the Troubleshooting section of the User's Manual (CD-
ROM Edition).
It is time to replace the lamp.
STANDBY
Replace with a new lamp cartridge.
When the Power is on
(Lit green)
Standby (Lit amber)
The lamp has reached the end of its service life.
STANDBY
The power will no longer turn on.
The projector can be used for 100 hours after the lamp
has reached the end of its service life.
Flashing amber for 60
Replace with a new lamp cartridge.
seconds, then lit amber
STANDBY
The lamp cover is open.
The lamp cover is not properly mounted. Mount it prop-
erly.
Lit red
The temperature is abnormally high.
• The temperature protector has been activated. If the
STANDBY
Lit red
• When the temperature protector is activated, the power
STANDBY
The fan has stopped.
Unplug the power cable and contact a store that sells
the
Lit amber
STANDBY
The lamp will not light.
Wait at least 90 seconds, then turn the power back on.
If the problem persists, unplug the power cable and
When the lamp has
contact a store that sells the
burned out during use:
Flashing amber for 90
seconds, then lit amber.
When the lamp does not
come on from the start:
Lit amber
STATUS Indicators
What you should do
room temperature is high, move the projector to a cool
place. If the projector's internal temperature is high, check
the cooling fan's ventilation slots and clean them if they
are clogged.
turns off and in some cases will not turn back on imme-
diately. In this case wait about 90 seconds, then try again.
PX5 for repairs.
E-15
STANDBY Indicators
PX5 for repairs.