Using The Saw For Cross Cuts; Cutting Curved Materials; Mitre Cuts; Bevel Cuts - PEUGEOT Energysaw-305DB Bedienungsanleitung

6. Once the blade has stopped, raise the cutting arm to the up position.

8. USING THE SAW FOR CROSS CUTS

While cutting material that is sufficiently narrow to allow the saw blade to make a cut using a downward movement (simi-
lar to that of a conventional mitre saw) instead of sliding the saw through the workpiece, the sliding movement of the saw
is locked in the rear position by tightening the locking knob of the slide rails. Push the cutting arm down to make the cut.
When the cut is complete, release the trigger switch and wait for the blade to come to a complete halt before lifting up the
saw head.

9. CUTTING CURVED MATERIALS

Inspect your workpiece before starting the cut.
If the piece is curved, set it against the guide fence with the
curved side as shown in the figure opposite.
IMPORTANT ! If you do not cut your curved work-
piece as shown, it could pinch the blade. The workpiece
could move suddenly, leading to serious injury.

10. MITRE CUTS

1. Raise the cutting arm to its highest position.
2. Release the mitre handle and set the mitre to the required angle with the handle.
3. Stand in the line of the angle to make the cut.
IMPORTANT !
Before attempting to make a mitre cut or a bevel cut, extend the guide fence on either side. The blade may come in
contact with the guide fence if the extensions are not fully out.

11. BEVEL CUTS

The cutting head of your sliding mitre saw may be tilted to any bevel angle, starting from a straight 90° cut to a cut with a
45° bevel to the right or left. To do so, please refer to the paragraph «Setting the bevel».
1. Release the bevel locking knob (P) Fig.18. Set the blade at
the required angle, using the bevel scale (O) as a guide.
2. Tighten the bevel locking knob (P). Stand to the left-hand
side of the saw to make the cut.
To use the double bevel feature, proceed as follows:
3. Put the cutting arm back in its highest position.
4. Loosen the bevel locking handle (P).
5. Pull the saw head bevel unlocking knob (Q) and set the
blade at the required angle using the bevel scale (O) as a
guide.
6. Tighten the bevel locking handle (P). Stand to the right-
hand side of the saw to make the cut.
60
17
18