Klarstein 10031574 Bedienungsanleitung Seite 12

(5) Installation
1. Attach a mirror clip to the back of each edge as shown using the 4 x short screws. Pre-drill the holes to stop
the MDF splitting, (using a 2mm diameter drill bit).
2. Place the suite to the wall, and mark the positions of the remaining holes on both mirror clips.
• For solid walls, drill the 2 holes approximately 35mm deep using a 6mm diameter drill bit.
• Note: if fitting the fire to plaster board with a cavity behind then propriety wall fixings (not supplied)
will be required.
3. Insert the wall plugs, then secure the suite with 2 x long screws (supplied).
4. Randomly place the pebbles in the open bed of the fire.
Supplied Mounting Material
12