8. Mount set 6, then remove the module-protecting Cover from sets 9 and 6.
Remove the module-protecting Cover.
(The protective Cover is attached on all four sides; only remove
fi rst the Cover on the sides where the sets meet.)
Insert Guide pins as shown in the
fi gure below.
9. Loosen the horizontal alignment screws on bracket 6, then attach set 6 to set 9.
(Caution: Loosen the right and left horizontal alignment screws gently in turn to prevent the set from tilting and
causing damage.)
6
9
6
9
<REAR>
2
5
8
<REAR>
2
5
8
13