LG MultiVision AB-VP200X Benutzerhandbuch Seite 10

2. Mount set 5, then remove the module-protecting Cover on sets 8 and 5.
5
8
3. Loosen the horizontal alignment screws on bracket 5, then attach set 5 to set 8.
(Caution: Loosen the right and left horizontal alignment screws gently in turn to prevent the set from tilting and causing damage.)
Fasten the right and left slides of set 5 using the right/left fi xing screws.
5
8
<Warning>
Push the top set to the bottom set until the stopper slightly
touches the bottom set. Pushing the product with force may
cause damage to the product.
10
Remove the module-protecting Cover.
(The protective Cover is attached on all four sides; only re-
move fi rst the Cover on the sides where the sets meet.)
<Horizontal Alignment Screw>
Loosen the screw to lower the set.
(Loosen the right and left screws gently in turn.)
Stopper
CAUTION
Loosen the left and right leveling screws slowly in turns. Otherwise, this may make
the set tilted, which may cause damage to the set.
Insert Guide pins as shown in the fi gure below.
<Right/Left Fixing Screw>
Tighten the screws to fix the left and right slides.
4