Seal; Screw (4X) - Axis Q87-E Dual PTZ Installationsanleitung

AXIS Q87-E Installation Guide
Attach the AXIS Q87-E Dual PTZ Network Camera Series to the Base
1. Make sure the seal is in position.
2. Remove the sunshield, which is placed on but not attached to, from the top cover.
3. Attach the Pan/Tilt control unit, motor and camera assembly to the base and tighten the screws (torque
4 Nm).
Use the alignment indicators to align the units. Incorrect alignment could cause damage to components.
4. Aim the dual PTZ network camera to the point of interest and focus the thermal network camera if required,
see Focus Adjustment - AXIS Q1921/AXIS Q1922, on page 18. See Access the Video Stream, on page 18 and the
Installation and Management Software CD for information on how to view the video stream.
5. Install the counterweights, see Install the Counterweights, on page 14 or install the selected illuminators (sold
separately), see page 16. Infrared LED Illuminators are available as accessories, see www.axis.com for
information of available illuminators.
Either counterweights or illuminators shall be installed. Any other installation method will void the war-
ranty and could leave the unit at a risk
1
2
1 Pan/Tilt control unit, motor and
camera assembly
2 Configuration board lid
3 Alignment indicators
Page 13
3
4
5
6
7
4

Seal

5 Base
6 Washer (4x)
7

Screw (4x)