Troubleshooting - Klarstein 10014353 Bedienungsanleitung

How to acquire the ice-cube
7. Use your ice-cube container to push forward the push botton for ice-cube (No.5 displayed in
above diagram), push it always, then the moving shaft for the ice-cube will activate, the ice-cube
will fall down into your ice-cube container from the ice-cube tap.
Note: Be sure to close the transparent window on the top of the unit when you want to get the ice-cube,
otherwise the moving shaft for the ice-cube will not start to work. The blue light will light on when
you push forward the push button, if this blue light is not on, the ice-cube will not fall down.
How to drain out the water inside the unit
8. When you clean the unit or change the drinkable water, need to drain out the left water in the
water reservoir, please disassemble the water drip tray fi rst, then unplug the water drain cap, the
water will fl ow out from the unit completely. If the unit is supplied with the plastic soft tube,
connect this soft tube with the water drain port, it can help you drain out the water easily.
9. Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level.
If unit isn't in use, drain all water left in the water reservoir.
PROBLEM
"Add Water" indicator is
on.
"Ice Full" indicator is on.
Ice cubes stick
together.
11

Troubleshooting

POSSIBLE CAUSE
Lack of Water.
There is too much ice.
The ice cycle is too long.
Water temperature in inner tank
is too low.
SOLUTION
Stop the ice maker, fi ll water, and press
"Power" button again to restart the unit.
Remove ice from ice basket.
Stop the ice maker, and restart it when
the ice blocks melt. Select the small size
ice cube selection.
Change the water in the inner Tank.
Temperature of water is better set
between 7℃-32℃ .