Electrolux IK3318CAR Benutzerinformation Seite 12

12 www.electrolux.com
Problem
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the "FastCool", or
after changing the tempera-
ture.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set. The "FastCool function" is
dEMo appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The "FastCool" is switch-
ed on.
This is normal, no error
has occurred.
Food products prevent
the water to flow into the
water collector.
The water outlet is clog-
ged.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
switched on.
The appliance is in dem-
onstration mode.
The temperature regulator
is not set correctly.
Solution
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastCool function".
The compressor starts after a
period of time.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water out-
let to the evaporative tray.
Switch off "FastCool function"
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FastCool function".
Keep the OK pressed for ap-
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.