Facom CL3.CTB50 Original Bedienungsanleitung Seite 15

2. Engage the battery in the right insertion direction.
3. Slide the battery until it is fully inserted.
4. Release the clip
Any attempt to remove the battery without pressing the clip causes premature wear of the tab and its
early damage.
Removing the battery is performed by pulling the battery tab once the locking clip released.
6. TIGHTENING A CLAMP
6.1 CHOOSING THE PLIERS
The tool range has two versions:
- The CL3.CTB50 pliers, for fl anges width 2.4 to 4.8mm / 0.094" to 0.189"
- The CL3.CTB120 pliers, for fl anges width 4.8 to 7.6mm / 0.189" to 0.299".
6.2 FLANGE TENSION ADJUSTMENT
Set the head to the tightening force required using the adjustment thumbscrew.
The table below provides the torque values for information.
Table of correspondence of the positions per pliers:
Adjustment thumbscrew
Position 1
Position 2
Position 3
Position 4
Position 5
Position 6
Position 7
Position 8
These torque ranges are indicative. To know precisely the values of torque of each tool, a checking report can be
ordered.
After 100,000 clamping cycles, we then advise to change the head to maintain clamping strength and
i
cutting quality.
When the clamp's tightening load is not known, this must be validated by iteration, by means of tests starting with
the weakest position and by increasing gradually.
NU-CL3.CTB50 - CL3.CTB120_0216.indd 15
CL3.CTB50
Min-max tension (N)
65 – 83
81 – 107
97 – 131
113 – 151
129 – 179
145 – 203
161 – 226
175 – 250
15
CL3.CTB120
Min-max tension (N)
175 – 250
214 – 297
Not authorized on this model of pliers
Not authorized on this model of pliers
Not authorized on this model of pliers
Not authorized on this model of pliers
Not authorized on this model of pliers
Not authorized on this model of pliers
2/9/2016 4:25:22 PM