ACME X9100 Bedienungsanleitung Seite 6

Tighten A propellers with black screws.
Tighten B propellers with silver screws.
Match the "I" mark on propellers to the "D" gap on motor shafts
when assembling, as shown in Figure 1 shows.
Make sure that the A and B propellers are installed correctly.
The X9100 will not fly if they are not properly installed.
Keep fingers and other body parts away from hazardous
moving parts.
StaRt fLYinG
fLiGHt enViRoMent
1. The flying area should be open and not contain tall buildings or other obstacles; steel
Structures within buildings interfere with the compass and GPS signal.
2. DO NOT fly in bad weather, such as strong wind, heavy snow, rain or fog.
3. (3) Keep away from barriers, people, power cables, trees, and other obstructions(4) Do NOT fly near radio towers or airports.
4. (5) DO NOT fly in restricted areas, and obey your country's laws and regulations.
paiRinG
Pairing is completed in the factory.
For re-pairing, press the Photo / Video button and power on the transmitter simultaneously until an "H" is displayed on remote control. Then power the drone and place it
very close to the transmitter. Then the pairing will be completed after one beep is heard.
If pairing fails, please switch off the drone and repeat the steps above.
6
High voltage cables Airports Magnetic Interference Rain