HQ Power VDPDMXC146 Bedienungsanleitung Seite 6

5) Recording a Scene
• Press MODE SELECT to select the 1-24 SINGLE / PRESET PARK function. The green LED
indicator lights up.
• Select the desired page with the PAGE button
• Slide both master faders to the top position (MASTER A = 10 & MASTER B = 0)
• Place the 24 channel sliders in the desired position.
• Press the RECORD button to store the scene in the memory.
• Slide both master faders to the lowest position (MASTER A = 0 & MASTER B = 10).
• Hold the record button
• Press the flash button of your choice (13-24)
• Release the RECORD button.
The scene is now stored under one of the keys of n°7 in fig. 1 on page 2
6) Deleting a Scene
• Select the desired page with the PAGE button
• Hold the RECORD button.
• Press the flash button (13 – 24) where the scene was stored twice
• Release the RECORD button
7) Recording a Chase
• Press MODE SELECT to select 1-24 SINGLE / PRESET PARK. The green LED indicator
lights up.
• Select the desired page with the PAGE button.
• Slide both master faders (MASTER A = 10 and MASTER B = 0) to the highest position
• Place the 24 channel sliders in the desired position.
• Press RECORD to store the scene in the memory
• Place the 24 channel sliders in the desired position again.
• Press RECORD to store this second scene in the memory
• Repeat the last two steps until a max. of 999 scenes have been programmed
• When you're done programming, slide both master faders (MASTER A = 0 and MASTER B =
10) to the bottom
• Press the desired flash button (13 – 24)
• Release the RECORD button
The chase is now stored under one of the keys of n°7 in fig. 1 on page 2.
8) Deleting a Step from a Programme
• Hold the EDIT button
• Press the desired flash button (13 – 24).
• Release the EDIT button. The yellow LED indicator of the selected scene is lit.
• Bring the speed fader down (to SHOW MODE) and use the STEP button to find the scene to
be deleted
• Press the DELETE button to remove the step.
VDPDMXC146 6 VELLEMAN