Measure Function - T4W TW-7 Bedienungsanleitung

www.t4w.eu
• Measur – measure function: takes measurements;
• Subst - ubstance function: allows to choose the measured material
• Memory – memory function: recalls the stored measurement values;
• Off – off function: switches the device off;
• Delete – delete function: deletes the stores measurement values;
• Zero – zeroing function: calibrates the device;
• Hold – hold function: freezes the measurement result on the display;
• Resol. – resolution function: switches between the measurement resolution;
• TEST UV – UV tester function: turns the tester on or off;
• LCD LED – back light function: turns the display back light on or off;
• Sound – sound function: turns the device's sounds on or off;
• Lang. – language function: switches between languages.
To select a function please press the

Measure function

fter You select this function the display will show the currently selected material,
e.g. and the battery indicator in the first line and
Zn/Al
The gauge is ready to take measurement.
After You put the sensor against the bodywork the result of the measurement
will be shown on the display in the second line. If the
the result will be refreshed every 1 – 2 seconds. After disabling the
it will be shown in real-time.
To store the measurement result press the
will appear next to the result confirming that it has been stored.
CAUTION!
overwritten automatically!
8
OK [MENU]
OK[MENU]
The device's storage capacity equals 200 results.
After exceeding the capacity the oldest results will be
button.
in the second.
----um
function is enabled
Hold
Hold
button. The
OPERATION MANUAL
TW-7/TW-7s
function
caption
*