Hold Function; Resolution Function; Funktion Button - T4W TW-7 Bedienungsanleitung

TW-7/TW-7s
the sensor against the calibration sheet and hold it. The calibration progress
will be shown on the display (
caption appears and You will hear a sound signal. The device returns to
function where You can check if the calibration has been done properly. After
pressing
OK [MENU]
CAUTION!
the sheet on the bodywork). Also, please avoid holding the sheet in Your hands as
this may affect the operation.
Please note that zeroing is recommended when the measurement conditions
are changing (e.g. the temperature or humidity rises or falls).

Hold function

This is a feature of high-end devices. It enables to take the measurement and
freeze the result on the display even after taking the sensor away from the
specimen. If You turn this function off, the results will be displayed in real-time.
To activate select the
by pressing the FUNKTION
button. To turn it off, choose

Resolution function

The gauge enables to choose between 2
measurement resolutions chosen with the
FUNKTION button:
• D=10 – the measurement is rounded up to 10µm
(faster)
• D=1 – the measurement is accurate up to 1µm (precise)
OPERATION MANUAL
33%, 66%,
the device returns to the main menu.
While zeroing, the calibration sheet should be placed
on a flat, stable non-metalic surface (e.g. do not place
function from the main menu and choose
Hold
button. Confirm the selection with the
Hold off
). After the procedure
100%
.
www.t4w.eu
OK...
Zero
Hold on
OK[MENU]
Resol.
D=10
11