Start / Stop - Texas CG230B Bedienungsanleitung

Filling of petrol - Smoking prohibited !
1. Unscrew the petrol lid. Place it on a clean surface.
2. Carefully pour the oil mixed fuel into the tank. Beware of spilling.
3. Screw the lid on tightly. Wipe away any spilled fuel.
4. It is normal that the engine smokes the first time it is used.
Notice ! Always turn off the engine before fuelling. Never put fuel on a machine that is
running or when the engine is hot (cooling time at least 2 minutes). Move more than 3
meters away from the place where you put fuel on the engine before it is started.
Fuelling (Smoking prohibited)
-
! Mix and store the fuel in containers that are approved for the purpose.
! Mix the fuel outdoors where there are no sparks or flames.
! Choose a bare place, turn off the engine and leave it to cool for 2 minutes
before refueling.
! Untighten the lid slowly to let out any pressure and to avoid that any fuel
spills out under the lid.
! Wipe off any spilled fuel. Move more than 3 meters away from the place
where you put fuel on the engine before it is started.
Check that the oil filter is moistened with oil.
If not so put a little two-stroke oil on the filter. Press out any surplus oil.

8. Start / Stop

How to start a cold engine
1. Place the brushcutter on a flat surface.
2. Switch to "Start".
3. Press 8-10 times on the fuel pump located
beneath the air filter.
4. Switch the choke to
5. Activate the safety handle and press the
throttle control, then lock the handle with the
locking pawl.
6. Pull the starter until the engine runs.
7. Switch the choke to running position
when the engine starts to be warm.
Safety
handle
www.texas.dk
Stop switch
Throttle
control
33