Cleaning And Maintenance - Bimar Cashmere HF200 Bedienungsanleitung

b1)
Set the right time: rotate the disc of the timer in the direction
shown by the arrow meeting the right time with the reference dial.
b2)
The on/off functions are regulated by small buttons on the crown:
if directed inwards, the appliance remains switched off – if directed
outwards it switches on. Push the button in one way or another (1
button corresponds to 30 minutes).
Adjust the position of the buttons to the times you want the fan heater
on (button to the outside) or off (button to the centre): at this point,
segments corresponding to the on and off periods are visible under the
crown.
The programmer will repeat the same functions until they are modified
or until the button remains in
the " " position.
b3)
If desired, select the "
b4)
To switch off the fan heater definitively, bring the button to "I",
rotate the selector to the "0" and take the plug out of the socket.
Never leave the appliance connected to the socket if it is not in use,
especially for long periods.
Anti-frost device
Insert the plug into the power socket, turn the selector knob in pos. "
", taste 24h programmer in pos. "I" and turn the thermostat knob
to the anti-frost position (•): this permits convector heater switching on
when the ambient temperature falls below +5°C.

CLEANING AND MAINTENANCE

Attention: before cleaning the fan heater, turn it off, remove the plug
from the outlet and wait for it to cool.
• Periodically check that the air-intake grill is not obstructed by fuzz or
threads.
• Use a soft, slightly damp cloth to clean the body; do not use metal
scouring pads or abrasive products.
• To clean and maintain of the grid, it is possible vacuum cleaner paying
attention not to damage the electrical resistance.
• When the appliance is not being used, cover it and put it in a dry place.
it is a good idea to put it back in its original packaging to protect it
from dust and humidity.
• If you decide not to use the fan heater, we recommend that you make
it inoperative by cutting the power cord (but first make sure you have
" (A) function using the button.
21