How To Treat - Beurer tria Bedienungsanleitung

HOW TO TREAT

1. TURN ON THE LASER, UNLOCK IT AND SET
THE TREATMENT LEVEL (SEE PAGE 11).
2. TOUCH AND HOLD THE TREATMENT WINDOW
TO THE SKIN UNTIL YOU HEAR TWO BEEPS.
• If you do not hear beeps, make sure that the
treatment window is flat against your skin.
The laser will only pulse when the whole window
is touching your skin.
• If you hear a buzzing tone instead of the second
beep, you lifted the device from the skin before
the pulse was over.
• Do not move the treatment window between
the first and second beep because this will disrupt
the laser pulse and reduce its effectiveness.
3. LIFT THE LASER AND PLACE IT BACK
ON THE SKIN SO THAT IT OVERLAPS
THE PREVIOUS SPOT.
• Each time you reposition the treatment window,
move it about half the distance of the window
(about 1/4 inch or 5 mm). This creates an
overlapping pattern in the treatment area, which
ensures you cover all the hair follicles. This works
out to about 25 laser pulses per square inch or
40 pulses per 10 square cm.
DO NOT treat repeatedly in the same spot.
Always move the treatment window to a new
area after each laser pulse. Failure to do so may
result in discomfort or skin heating, which could
cause skin injury.
4. KEEP
5. TURN
Tria Beauty 12
GB
COVER
Use th
best re
how m
area p
are ap
and nu
PULSE
BOD
Unde
Bikin
Uppe
Uppe
Lowe
Pulse c
THE P
Repeat
or unti
13