Nice FLOXR-Serie Installierungs-Und Gebrauchsanleitungen Und Hinweise Seite 11

5.4 – Locking the memory
There are two ways to do this:
– Locking the memory via the hardware (paragraph 5.4.1)
– Locking the memory via the software (paragraph 5.4.2)
5.4.1 – Activating the memory lock: hardware
This locking mode is very simple to perform but it is not very
safe. Indeed, it can easily be cancelled by outsiders.
IMPORTANT! – The memory enabling/disabling opera-
tions must be performed with the receiver not powered.
After inserting the desired transmitter codes, proceed as
shown in fig. 6: cut (X) the track indicated by the arrow.
If you later wish to insert other codes, proceed as shown in
fig. 6: join (Y) the two spots with a drop of tin.
5.4.2 – Activating and deactivating the memory lock:
software
This is a safer way to activate the memory lock. In fact, you
X
6
need to have a transmitter that has already been stored in
the receiver to deactivate it.
• Activating the memory lock
01. Press and immediately release key P1 (fig. 1) on the
receiver;
02. Wait for LED L1 to flash twice, indicating the time is up
(approx. 5 sec.) and at the 2nd flash, press key P1 and
then release it when LED L1 is turned off.
Next, LED L1 emits two flashes: if the second flash lasts
longer than the first, this means that the memory lock has
been activated. If the flashes last the same, this means that
the memory lock has not been activated. In this case, repeat
the process from step 01.
• Deactivating the memory lock
To deactivate the memory lock, you need to have a transmit-
ter that has already been stored. Proceed as follows:
01. Press and immediately release key P1 (fig. 1) on the
receiver: LED L1 is turned on for 5 sec.;
02. During these 5 sec. press any key on the transmitter, to
transmit the code, until LED L1 is turned off;
Y
03. Then release the key on the transmitter and wait for 1
sec.;
04. Press and keep any key on the transmitter pressed, to
send the code: LED L1 will emit 4 flashes to indicate that
that code is already on the list;
05. During the 4th flash, press key P1 and release it when
LED L1 is turned off.
Next, LED L1 will emit 2 flashes for the same amount of time,
which means that the memory lock is no longer activated.
English - 9