Maintenance - EMAK BC 300 D-PU Wartungsanleitung

7. MAINTENANCE

Please note that the following maintenance intervals apply for normal operating conditions only. If your daily work
requires longer than normal or harsh cutting conditions are present, then the suggested intervals should be shortened
accordingly.
Complete Machine
Controls (STOP button, Choke Lever, Throttle
Trigger, Trigger interlock)
Fuel Tank
Fuel Filter and tube
All Accessible Screws and Nuts (Not Adjusting Screws)
Air Filter
Cylinder Fins
Starter System Vents
Starter Rope
Carburetor
Spark Plug
Vibration Mounts
Attachments coupling
Maintenance Chart
Inspect (Leaks, Cracks, and Wear)
Clean after finishing daily work
Check Operation
Inspect (Leaks, Cracks, and Wear)
Clean
Inspect
Clean, Replace Filter Element
Inspect
Retighten
Clean
Replace
Clean
Clean after finishing daily work
Inspect (Damage, and Wear)
Replace
Check Idle (Cutting Attachments must not
rotate at idle)
Check Electrode Gap
Replace
Inspect (Damage, and Wear)
Replace by Dealer
Grease
x
x
x
x
x
x
x
x
x
x
x x
x x
x
x
x
x
x
x
x x
x
x x
x x
GB
21