Turn On/Off And Reset Device; Commands To The Instrument - Orbis Coditel 2 Bedienungsanleitung

TURN ON/OFF AND RESET DEVICE

• Turn off the instrument:
➢ Hold approximately 10 seconds for either the "1-SET" or "2" until all LEDs off.
During the pression of the key, the output led
green (or yellow) for the first 5 seconds and green/ red for the other 5 seconds.
• Turn on the instrument without reset
➢ Press "2". The LED
(or yellow), indicating the correct reception of the GSM signal.
• Turn on the instrument with reset
➢ Press the "1-SET". The input and output leds will illuminate for a few seconds;
waiting for they go out and press "1-SET" key.
The LEDs will flash simultaneously a pair of times indicating that the reset occurred.
Note: The reset erases all data, settings and users stored tool and restore
factory defaults (see box on).

COMMANDS TO THE INSTRUMENT

The two relay outputs can be piloted in the following ways:
− with the keys on the front panel
− via ring or text message from an enabled number
− following an alarm in one of the inputs present
Commands from ring or text message
The outputs can be commanded from a distance via a text message or a telephone ring.
The structure of a text message is as follows:
[password] [separator] [command] [parameter1] [separator]..[parameterN]
[password] 
[separator] 
[command] 
[parameter] 
OPERATION
will be green initially fixed and then begin to flashing green
numerical field of a maximum of 8 figures
comprised of one or more space characters
command recognised by the device
series of parameters relative to the command
- 38 -
User Manual CODITEL 2
blinks quickly and the led blinks