Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.3 Function with Sync Cord
• Connect your device with the corresponding Sync Cord to your camera.
7.4 Switching the device on / off
• to switch the device on and off hold the On/Off switch depressed for about
2 seconds.
7.5 Operation with flash function
• Switch the device on with the On/Off switch.
• With the adjusting wheel you can set the power from 1/1 to 1/128 in
1/3 stages.
• If the display shows the reading OFF – no flash can be triggered.
Turn the adjusting wheel to set the desired flash power.
1/1-0.3
1/1
1/2+0.7
Adjusting different modes:
•
Use in mode M:
Press the Mode button to change to mode M. In mode M all actions can
be triggered manually. Function via Sync Cord possible. The photo cell is
deactivated.
•
Use in mode S1:
Press the Mode button to change to mode S1. In mode S1 you can use
you flash as a Slave flash. The flash is triggered synchronously with the
camera flash or the master flash.
•
Use in mode S2:
Press the Mode button to change to mode S2. In mode S2 you can use
you flash as a Slave flash with different light effects. TTL system. In mode
S2 the 1. flash from the master device is ignored, triggering will take place
together with the 2. Master flash.
•
Use in mode RPT:
Press the Mode button to change to mode RPT. In stroboscope mode you
can trigger a series of flashes. (e.g. shots with moving objects). You can
adjust the flash frequency (number of flashes per second specified in Hz),
the number of flashes and the flash power.
1/1-0.7
1/2
1/2+0.3
1/2-0.3
1/2-0.7
1/4+0.7
1/4+0.3
...
1/4
OF
...
35
Werbung
Inhaltsverzeichnis
