Operating The Device; Adjusting The Height; Function With Radio Remote Trigger - WalimeXPro RingFlash HS 400 Gebrauchsanleitung

NOTE
Compare the local electric power supply with the connection values of
the device. Should the connection values not match, please contact
info@walimexpro.de or phone +49 8432-9489-0.
NOTE
The time required for a complete charging of the powerpack is
approx. 2,5 hours.
NOTE
In order to ensure the longevity of the power pack you must charge the po-
wer pack to full capacity before using the video light for the first time. Use
the power pack until it is completely discharged. Then recharge the power
pack to full capacity. Repeat these steps about 2 times.
Battery status indicator
Battery status
> 25 %
7-25 %
< 7 %

7. Operating the device

7.1 Adjusting the height

• Loosen the fastening screw for height adjustment.
• Adjust the desired height.
• Tighten the fastening screw for height adjustment.

7.2 Function with radio remote trigger

• Plug your receiver (optional) with USB interface into the socket for the
radio remote trigger.
• Plug the trigger on your camera shoe.
34
Battery power indicator
No symbol in the display
Display
flashes
Flash power (1/1)
ca. 100-400 x
ca. 30-100 x
Ca. < 30 x