Stand Maintenance; Cleaning And Lubrication; Daily Maintenance; Maintenance - Husqvarna DS70 AT Bedienungsanweisung

Stand maintenance

The lifetime of your machine can be extended considerably if
it is used, cared for and maintained in the proper manner.
IMPORTANT! All types of repairs may only be carried out by
authorised repairmen. This is so that the operators are not
exposed to great risks.

Cleaning and lubrication

IMPORTANT! Remove the drill motor.
• It is important that the drill stand is kept clean for
functionality to be maintained.
• Clean the stand using a high pressure washer and then
wipe dry.
• Lubricate the moving parts on the stand. Apply standard
grease to counteract corrosion on the contact surfaces.

Daily maintenance

1 Check that nuts and screws are tight.
2 Clean the outside of the machine.
3 Check the slide function on the glide plates. Change the
glide plates if there is a backlash between the glide plates
and the drill column.
Changing glide plates
1 Remove the drill motor.
2 Remove the feeder housing from the column.

MAINTENANCE

3 Loosen the adjustment screws.
4 Loosen 2*4 clamping screws for the glide plates.
5 Remove the glide plates.
6 Lay down the stand.
7 Mount a new lower glide plate on the column. Fit the
feeder housing on the column and fasten the lower glide
plate on the feeder housing. Mount a new upper glide
plate on the column. Fasten the upper glide plate on the
feeder housing.
IMPORTANT! The glide plates' surfaces must be parallel.
8 Fasten the rear clamping screws (4). Then fasten the front
(4) clamping screws.
9 Adjust the play between column and feeder housing with
the adjustment screws.
– 11
English