Charging The Battery Pack - Kenwood ProTalk DIGITAL TK-3401D Benutzerhandbuch

INSTALLING/ REMOVING THE BATTERY PACK
◆
Do not short the battery terminals or dispose of the battery by fi re.
◆
Never attempt to remove the casing from the battery pack.
◆
Install the battery pack after cleaning the battery pack contacts and
the transceiver terminals.

CHARGING THE BATTERY PACK

The battery pack is not charged at the factory; charge it before use.
ATTENTION:
◆ Always switch OFF a transceiver equipped with a battery pack
before inserting the transceiver into the charger.
1 Plug the AC adapter cable into the jack located on the rear
of the charger.
2 Plug the AC adapter into an AC outlet.
2
PREPARATION
1 Align the battery pack with the
back of the transceiver, then
press the battery pack and
transceiver fi rmly together until
the release latch on the base of
the transceiver locks.
2 To remove the battery pack, lift the
safety catch on the base of the
transceiver, then press the release
latch underneath the safety catch.
3 While pressing the release latch,
pull the battery pack away from
the transceiver.