Preparation; Installing/ Removing The (Optional) Battery Pack - Kenwood NX-5000 series Benutzerhandbuch

INSTALLING/ REMOVING THE (OPTIONAL) BATTERY
PACK
• Do not short the battery terminals or dispose of the battery by fi re.
• Never attempt to remove the casing from the battery pack.
• Install the battery pack after cleaning the battery pack contacts and
the transceiver terminals.
• Before charging a battery pack that is attached to the transceiver,
ensure that the safety catch is fi rmly closed.
• If the release latch is tilted and the battery
pack is not attached to the transceiver, return
the release latch to its original position using
your fi nger.
1 Match the guides of the battery pack with the corresponding
grooves on the upper rear of the transceiver, then fi rmly
press the battery pack to lock it in place.
2 Lock the safety catch to prevent accidentally pressing the
release latch and removing the battery pack.
3 To remove the battery pack, lift the safety catch, press the
release latch, then pull the battery pack away from the
transceiver.

PREPARATION

1
2
3
Release latch
Release latch
Safety catch
13