Herunterladen Inhalt Inhalt Diese Seite drucken

Preparation; Installing/ Removing The (Optional) Battery Pack; Installing The (Optional) Antenna - Kenwood Nexedge serie Kurzanleitung

Vorschau ausblenden Andere Handbücher für Nexedge serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 67

INSTALLING/ REMOVING THE (OPTIONAL) BATTERY PACK

1 Match the guides of the battery pack with the grooves on
the upper rear of the transceiver, then fi rmly press the
battery pack in place.
2 Lock the safety catch to prevent accidentally releasing the
battery pack.
3 To remove the battery pack, lift the safety catch, press the
release latch, then pull the battery pack away from the
transceiver.
Note:
◆ For battery pack charging procedures and usage, refer to the
battery charger Instruction Manual.
◆ Before charging a battery pack that is attached to the
transceiver, ensure that the safety catch is fi rmly closed.
◆ While operating the transceiver using a Li-ion battery pack in
areas with an ambient temperature of –10°C/ +14°F and lower,
operating time may be shortened.
◆ Install the battery pack after cleaning the battery pack contacts
and the transceiver terminals.

INSTALLING THE (OPTIONAL) ANTENNA

Screw the antenna into the connector
on the top of the transceiver by holding
the antenna at its base and turning
it clockwise until secure.
2

PREPARATION

1
2
3
Release latch
Safety catch
Optional
antenna

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis