Kenwood ProTalk DIGITAL TK-3401D Benutzerhandbuch Seite 15

INSTALLING THE OPTIONAL SPEAKER/ MICROPHONE
(OR HEADSET)
Note:
◆ The transceiver is not fully water resistant when using a speaker/
microphone or headset.
1 Insert the speaker/ microphone (or
headset) plugs into the speaker/
microphone jacks of the transceiver.
2 Place the Locking bracket over the
speaker/ microphone (or headset)
plugs so that the locking tabs insert
into the transceiver grooves.
• Push down on the Locking
bracket to slide it into place.
3 While holding the Locking bracket in
place, push it towards the bottom of
the transceiver until the tabs on the
bracket click into place.
• To remove the Locking bracket,
push the bracket up from the
base.
5