Status Indication - Inateck P6 Bedienungsanleitung

1. Connect Inateck P6 with computer via USB cable
2. Power on Inateck P6 by toggling switch from OFF to ON and short
press the trigger. Inateck P6 will continuously beep. Beep stops
after successful connection.
3. Open a f ile on computer and move cursor to the blank where
scanning output should be placed. Scanning results can be
displayed on computer then.
Function Setup
(Note: The barcode marked by * means default setting of Inateck P6.)
Users must read setup barcodes in order to change the default
settings in Inateck P6 Barcode Scanner.

Status indication

Buzzer Indication
Beeping
One short high note （ 100ms）
One short high note （ 20ms）
One long high note （ 400ms）
One or several long high notes
（800ms）
Three chord sounds
Two short notes （ tone from low
to high）
Two short beeps (tone from
high to low)
Scan"Enter setup"barcode;
Change scanner setting by
scanning certain function
setup barcode;
Scan "Exit with save" barcode
to finish the setup.
Meaning
Read barcode successfully
Data upload from scanner to Computer
Wrong Setup
（on setup status, blue LED stays on）
Invalid scanning due to full buffer
(Scanned barcode not saved.)
USB being conf igured （It happens when
USB cable is inserted）
Enter setup mode （ Blue LED on）
Exit setup mode （ Blue LED off）
Correct Setup
The connection between Inateck P6 and
computer is disrupted.
3