This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications or change to
this equipment. Such modifications or change could void the
user's authority to operate the equipment.
This radio transmitter (identify the device by certification
number or model number if Category II) has been approved by
Industry Canada to operate with the antenna types listed below
with the maximum permissible gain indicated. Antenna types
not included in this list, having a gain greater than the maximum
gain indicated for that type, are strictly prohibited for use with
this device.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for
help.
Hereby, SHENZHEN LIXIN TECHNOLOGY CO ., LTD, declares
that this Barcode Scanner / Inateck P6, is In compliance with the
essential Requirements and other relevant provisions of
Directive 1999/5/EC.
Environment friendly disposal
You can help protect the environment!
Please remember to respect the local
regulations: hand in the non-working electrical
equipments to an appropriate waste disposal
centre.