Starting Operation - Bosch PDA 180 Betriebsanleitung

OBJ_BUCH-617-001.book Page 17 Thursday, December 13, 2007 2:21 PM
To remove the sanding sheet 4, grasp it at one of
the tips and pull it off from the sanding plate 5.
Sanding accessories, such as fleece pads/polish-
ing cloth pads, are attached to the sanding plate
in the same manner.
Selecting the Sanding Sheet
Depending on the material to be worked and the
required rate of material removal, different sand-
ing sheets are available:
Grain size
For the working of all
wooden materials
For coarse-sanding,
e. g. of rough, un-
planed beams and
boards coarse
For face sanding and
planing small irregu-
larities medium 80, 100, 120
For finish and fine
sanding of hard
woods fine
For the working of
paint/enamel coats
or primers and fillers
For sanding off paint coarse
For sanding primer medium 80, 100, 120
For final sanding of
primers before coating fine
For reworking or polishing, especially of metal
and stone, use fleece/polishing cloth pad.
Depending on the desired surface quality of the
workpiece, different fleece types or polishing
cloth pads are to be used.
Replacing the Sanding Plate
(see figure C)
Slide the SDS button for release of the sand-
ing plate 6 all the way to the right.
Bosch Power Tools
Remove the sanding plate 5.
Guide the sanding plate 5 from below against
the sanding plate holder and firmly press
them together.
Slide the SDS button for release of the sand-
ing plate 6 all the way to the left.
If, e. g., the front tip of the sanding sheet is worn,
you can also remove the complete sanding plate
and reattach it turned by 120°.
Specialty Sanding Plates
You can replace the supplied sanding plate 5
40 — 240
with a specialty sanding plate, which is available
as an accessory.
The specialty sanding plate is attached in the
same manner as the one supplied.
Attach and remove the respective sanding sheets
in the same manner as when changing original
sanding sheets.
40, 60
Pad Extender (see figure D)
With the pad extender 8 you can sand surfaces
that are difficult to access, such as sills on win-
dows, cabinets or doors.
Pad Extender, Narrow (see figure E)
180, 240
With the narrow pad extender 10 you can sand
40 — 320
narrow openings, slots and passages.
Pad Extender, Narrow Rounded (see figure F)
The narrow rounded pad extender 11 allows you
to sand curved and hollow areas or surfaces that
40, 60
are curved inward, such as on furniture, rails or
heating radiators.
180, 240, 320
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V can
also be operated with 220 V.
English | 17
1 609 929 N22 | (13.12.07)