Important Safety Instructions - EuroLite NODE 8 Bedienungsanleitung

Operating conditions
This device has been designed for indoor use
only. Keep this device away from rain and
moisture.
Electric shock caused by short-circuit
Be careful with your operations. With a
dangerous voltage you can suffer a dangerous
electric shock when touching the wires!
• This device has left our premises in absolutely
perfect condition. In order to maintain this
condition and to ensure a safe operation, it is
absolutely necessary for the user to follow the
safety instructions and warning notes written in this
user manual.
• Damages caused by the disregard of this user
manual are not subject to warranty. The dealer will
not accept liability for any resulting defects or
problems.
• Unpack and carefully check that there is no
transportation damage before using the device.
Should you notice any damages, do not take the
device into operation and immediately consult your
local dealer.
• Keep the packaging. To fully protect the device
against vibration, dust and moisture during
transportation or storage use the original
packaging.
• This device falls under protection class I. The
power plug must only be plugged into a protection
class I outlet. The voltage and frequency must
exactly be the same as stated on the device.
Wrong voltages or power outlets can lead to the
destruction of the device and to mortal electrical
shock.
• Always plug in the power plug least. The power
plug must always be inserted without force. Make
sure that the plug is tightly connected with the
outlet.
• Never let the power cord come into contact with
other cables! Handle the power cord and all
connections with the mains with particular caution!
Never touch them with wet hands, as this could
lead to mortal electrical shock.
• Never modify, bend, strain mechanically, put
pressure on, pull or heat up the power cord. Never
operate next to sources of heat or cold. Disregard
can lead to power cord damages, fire or mortal
electrical shock.
• The cable insert or the female part in the device
must never be strained. There must always be
sufficient cable to the device. Otherwise, the cable
may be damaged which may lead to mortal
damage.

IMPORTANT SAFETY INSTRUCTIONS

CAUTION!
DANGER!
• Make sure that the power cord is never crimped or
damaged by sharp edges. Check the device and
the power cord from time to time.
• If extension cords are used, make sure that the
core diameter is sufficient for the required power
consumption of the device. All warnings
concerning the power cords are also valid for
possible extension cords.
• Always disconnect from the mains, when the
device is not in use or before cleaning it. Only
handle the power cord by the plug. Never pull out
the plug by tugging the power cord. Otherwise, the
cable or plug can be damaged leading to mortal
electrical shock. If the power plug or the power
switch is not accessible, the device must be
disconnected via the mains.
• If the power plug or the device is dusty, the device
must be taken out of operation, disconnected and
then be cleaned with a dry cloth. Dust can reduce
the insulation which may lead to mortal electrical
shock. More severe dirt in and at the device should
only be removed by a specialist.
• There must never enter any liquid into power
outlets, extension cords or any holes in the
housing of the device. If you suppose that also a
minimal amount of liquid may have entered the
device, it must immediately be disconnected. This
is also valid, if the device was exposed to high
humidity. Also if the device is still running, the
device must be checked by a specialist if the liquid
has reduced any insulation. Reduced insulation
can cause mortal electrical shock.
• This device must never be operated or stockpiled
in surroundings where splash water, rain, moisture
or fog may harm the device. Moisture or very high
humidity can reduce the insulation and lead to
mortal electrical shocks.
• There must never be any objects entering into the
device. This is especially valid for metal parts. If
any metal parts like staples or coarse metal chips
enter into the device, the device must be taken out
of operation and disconnected immediately.
Malfunction or short-circuits caused by metal parts
may cause mortal injuries.
• There are no serviceable parts inside the device.
Maintenance and service operations are only to be
carried out by authorized dealers!
• Disconnect from mains before cleaning! Never use
solvents or aggressive detergents in order to clean
the device! Rather use a soft and damp cloth.
13 • EN