Husqvarna K 770 Dry Cut Bedienungsanweisung Seite 27

To adjust the tension of the recoil
spring
1. Put the rope through the cut-out in the starter pulley.
Wind the rope 3 turns clockwise around the center of
the starter pulley.
2. Pull the starter knob to adjust the tension of the
recoil spring.
3. Put the rope through the cut-out in the starter pulley.
Wind the rope 4 turns clockwise around the center of
the starter pulley.
4. Pull the starter knob to adjust the tension of the
recoil spring.
Note: The starter knob goes to its correct start
position after adjusting the tension of the recoil
spring.
5. Do a check that the recoil spring is not at its end
position by pulling out the starter rope fully. Make the
starter pulley go slow with your thumb. Make sure
that the starter pulley can be turned half a turn or
more before the recoil spring stops the movements.
To remove the spring assembly
WARNING: Always use eye protection when
you disassemble the spring assembly. There
is a risk for eye injury, especially if a spring
is broken.
861 - 003 - 12.11.2018
1. Remove the 2 screws on the spring assembly.
2. Push the 2 brackets on the snap locks with a
screwdriver.
To clean the spring assembly
CAUTION: Do not remove the spring from
the assembly.
1. Blow the spring with compressed air until it is clean.
2. Apply a light oil to the spring.
To attach the spring assembly
• Assemble in the opposite sequence of
the spring assembly on page 27 .
To install the starter housing
CAUTION: The starter pawls must come
into the correct position against the starter
pulley sleeve.
1. Pull out the starter rope approximately 0.5 m.
2. Keep the position of the starter rope and put the
starter against the product.
To remove
27