KWB 0628-10 Gebrauchsanleitung Seite 2

-
-Art.: 0628-10
Instructions for use
A
L
B
C
E
K
H
G
A Bubble level
B Turning knob
C Switch
D Laser
E Wall holder
F Levelling table
G Laser enhancement glasses
H Stop pin
I Setting screws
K Push button
L Battery compartment
Important: Please read the operating instructions
carefully before use.
The kwb Laser-Mouse allows you to project an
unbroken laser line instead of a laser point. This can
be freely swivelled within a 90° angle. The laser Mouse
is superbly suitable for transferring heights or for
setting measured points in an uneven plane (e.g.
hanging pictures in a stairwell)
Operating Instructions
Switch on the laser by depressing the switch. To switch off pull
the switch back up again. Fig. 1
The laser now projects an unbroken laser line. The turning knob
can be used to freely swivel the laser line in the 90° angle. Fig.
2
D
Fig. 1
AVOID
EXPOSURE
Laser radiation is omitted
through this aperture
C
AVOID
EXPOSURE
Laser radiation is omitted
through this aperture
I
Using the levelling table
F
Use the levelling table to compensate for floor unevenness.
Align the Laser-Mouse on the stop pin.
The integral magnet plate securely connects the Laser-Mouse
with the levelling table. The setting screws can be used to set
the laser Mouse level.
H
Using a photographic tripod
If required the Laser-Mouse can also be
mounted on a standard
photographic tripod.
Fig. 2
I
F
H
Using the wall holder
The wall holder permits the Laser-Mouse to be mounted on
a light-weight wall. Remove the protective cap and align the
Laser-Mouse on the stop pin. Pressure on the red buttons
drives six small nails into the wall, thus fastening the Laser-
Mouse. After ending the work the Laser-Mouse can be simply
removed from the wall.
K
H
Protective cap
Using the laser viewing glasses
In unfavourable light conditions, or if the laser line can barely
be recognised, use the accompanying laser viewing glasses
to increase the contrast.
Examles of use
Changing the battery
When the brightness of the laser beam begins to fade, the
batteries need to be changed. In order to change the batteries,
unscrew the battery compartment. Used batteries must be
disposed off correctly.
Nails
05.03.04/B