La Sommeliere VIP 265 Bedienungsanleitung Seite 8

GB
Temperature setting at the
bottom of the appliance
Push SET2. Then the temperature at the
bottom of the appliance can be adjusted
up and down by means of the "up and
down" buttons. The temperature can be
adjusted from 5 to 22°C, however so that
the temperature cannot be set at a higher
temperature than the actual set point for
the upper temperature sensor.
Alarm devices
There is a sub-alarm for the low-tempe-
rature sensor and an excess-alarm for
the high-temperature sensor.
The alarm consists of a beeper and a
warning on the display.
Alarm for high temperature: beep sound +
alternating display of "HtA" and actual
temperature
Alarm for low temperature: beep sound +
alternating display of "LtA" and actual
temperature
The alarm temperature depends on the
set points.
The beep sound can be cancelled by
pushing a random thermostat button.
Push the on/off button to erase the display
alarm, first for cancelling the alarm, then
again for restarting the compressor.
Light
To turn off the lights, press once
Two-zone setting for serving
temperature
Typical serving temperature settings for the
top and bottom sections are 16°C and 6°C
respectively. With these settings, a suitable
temperature gradient will be achieved in
the cabinet for the storage of various types
of wine distributed from top to bottom as
follows:
● heavy red wines +16 to +19°C
● rosé and light red wines +12 to +16°C
● white wines +10 to +12°C
● champagne and sparkling wines +6 to
+8°C
It is recommended that wine be served at a
temperature which is a couple of degrees
lower than the desired drinking temperature
as the wine will be warmed slightly when it is
poured into the glass.
Single-zone setting for long-
term storage
For long-term wine storage, the top and bot-
tom sections should both be set at 12°C. With
identical settings for the top and bottom
sections, the controls will maintain an even
temperature throughout the cabinet.
However, the temperature in the room will
gradually affect the temperature in the
cabinet through its door and sides, creating a
slight temperature gradient from top to
bottom. The controls will maintain the set
temperature at the bottom of the cabinet, and
any deviation from the setting will the- refore
occur at the top.
The difference will vary from 0 to 3°C,
depending on
8
the ambient temperature.