Termozeta SUPER COMPACT Gebrauchsanweisung Seite 15

• Completely unwind the power cord (9) and plug into the outlet.
• Put switch (2) to position "1" in order to switch on the appliance.
• Turn the iron temperature control knob (14) to the steam ironing
position.
• The pilot light (17) on the iron will go on immediately and will go out
a few minutes later, when the required temperature is reached.
• When the pilot light (4) goes on, it is possible to use the jet of steam.
The pilot light will be on until the appliance is turned off.
• During operation, the iron light (17) and the "steam ready" pilot light (4)
go on and then automatically go out indicating that the iron temperature
and the pressure in the boiler are constantly under control.
• Rest the iron on the boiler base (6) during ironing pauses.
IRONING
• Press button (16) on the iron for the steam jet: the steam will stop
coming out when you release the button.
• To use the continuous steam function, press the steam button (16)
and at the same time slide cursor (16a) towards the cork handle. To
disable this function, slide cursor (16a) in the opposite direction to
the handle.
• With the iron held upright at a distance of about 20 cm you can use the
jet of steam to smooth out creases and freshen up clothes while they
are hanging. Avoid carrying out this operation on any worn garment
as the steam is extremely hot and it is possible to get burned.
• Before ironing delicate fabrics it is best to make trial run on a
hidden piece e.g. the hem.
• We advise you to iron more delicate fabrics needing low
temperatures first, then go on ironing more resistant fabrics
needing higher temperatures.
WARNING!
Some drops of water may leak out of the iron soleplate (12) when the
first jet of steam starts coming out; this is quite normal and is due to
condensation forming inside the iron-boiler connecting tube (8).
This will disappear with the following jets of steam. It is therefore not
recommended to point the first jet of steam directly on the item to be
ironed. The iron must be used and left at rest on a firm surface.
ENGLISH